10" Beatbox Installation

In this guide we will cover the installation of the RoamRig 10" Beatbox stereo into a VS30 Sprinter chassis. This is NOT the same as the Beatbox Blackbird.

If you are considering a DIY installation, read the installation guide first and let us know if you have any questions before getting started. Or, check out our installer map to find a dealer who can install it for you.

Installing the new Beatbox Blackbird? Many of the installation steps for the 10" Beatbox and the Beatbox Blackbird are the same, so this guide may be helpful. We're currently working on detailed installation instructions for the Beatbox Blackbird. Until they're ready, please refer to this installation video in addition to the steps in this guide.

Beatbox 1

Difficulty

Moderate

Time Needed

2-4 Hours

Required Tools

Small Pry Tool Set
E12 External Torx Socket
Socket Wrench 3/8" Drive
Wire Cutters
10mm Deep Socket
Socket Wrench
Long Socket Extension
Magnet Pick Up Tool
T20 Torx Bit
T25 Torx Bit
T30 Torx Bit

Trim Removal Tool Kit
16mm Socket
Various Length Extensions for Sockets
Drill/Impact Driver
Oscillating Tool
Wire Strippers
Wire Crimpers
Heat Gun or Torch
9/32" Drill Bit
3/8" Drive Extension - 3"
Torque Wrench 3/8" Drive

Click here to download the 10" Beatbox Installation Guide.

All Beatbox stereos ship with the amplifier settings pre-set. Do not adjust the settings during installation. Read more on our Beatbox settings page.